Oxygen automatic upper and dischargeequipmentscheme andparameters To address the issues of difficulty in hiring, high wages, and low efficiency in aluminum profile oxidation lines, we are accelerating the process of fully automatic horizontal oxidation lines for aluminum profiles. The solar-powered automatic loading and unloading equipment ensures that aluminum profiles are directly transported from the sandblasting machine to the oxidation line, then automatically discharged after oxidation, and finally loaded into frames or sent to the packaging workshop. This entire process significantly increases production efficiency and reduces the number of workers required. 一.The automatic upper row process is shown in the following figure: Equipment functions: （1） Automatic top row A： Set the length of aluminum profile. B: Set the upper row spacing of aluminum profiles. （3）Automatic downplay A：Set the length of aluminum profile. B：Set the output interval of aluminum profiles. C: Set the output number of aluminum profiles. 二.：The function configuration is as follows (some parameters may vary according to the customer’s site conditions and needs): 1.. Automatic upper row Name Operate mode Job ins- truction Equipment conf- iguration Beam conveyor frame The top-mounted roller chain is used to tran- sport the empty cross- beam to the pit edge, where the cylinder arm delivers it to the li- fting device for auto- matic loading. Oncefully loaded, the cy l- inder arm moves the crossbeam to the other side, where it is again transported by the top- mounted roller chain to the position for stor- ing full rows of hang- ing beams. Replacement of a crossbeam: 45 se- conds per cycle 1. The beam conveying frame is divided into front and rear storage beam fra- mes2
